Jump to content
  • Welcome, Guest!

    Welcome to Backcountry 4x4's online community! Consider creating a free account to take part in our discussions, share photos / videos, and start "web wheeling" with us!

What did you do to your rig today?


autumnwalker

Recommended Posts

  • Replies 4.5k
  • Created
  • Last Reply

would like to go but we've got visitors, so it's gonna take some skilled negotiation to get a pass....I'll give it my best shot ;-)

are you going ?

Bring the guys, leave the wives at home ;)!

...how difficult is it to PD? can you do it with tires still mounted?

Buy it in a rattle can and do the same as you already did with the cards and Krylon B)

Link to comment
Share on other sites

Looking good Derek. I'm thinking of options for my ol'school slots...how difficult is it to PD? can you do it with tires still mounted?

Thanks! It's really easy to apply, and the great thing is, if you don't like it, you can peel it right back off! The stuff is stupid expensive here though. The cheapest I've found it is around $20 a can, and it's only around $5 a can in the US. We had friends pick me up a couple of cans when they went to Maine, and I'm going to get more in the summer when we come home from Ontario.

would like to go but we've got visitors, so it's gonna take some skilled negotiation to get a pass....I'll give it my best shot ;-)

are you going ?

Just tell her you're going out to get some milk, then when you get back tell her there was construction and you got tied up, and that's why the trucks dirty! :lol:

Link to comment
Share on other sites

Last week I cut out the drivers side floor in my XJ and was waiting for the power in the garage to be hooked up for my welder... Well it's hooked up now and I got side tracked and started tacking together a rear bumper I bought from Creepy (nsjc) last summer...

Link to comment
Share on other sites

more work to the bumper...
post-639-0-23281500-1372211157_thumb.jpg
post-639-0-65540300-1372211164_thumb.jpg
post-639-0-98647100-1372211181_thumb.jpg
post-639-0-95721500-1372211189_thumb.jpg
post-639-0-46843800-1372211207_thumb.jpg
post-639-0-85530300-1372211198_thumb.jpg
post-639-0-21342600-1372211215_thumb.jpg
post-639-0-40126400-1372211221_thumb.jpg

The holes in the mounting plates are too small and too close to the edge to drill large enough to fit stock bolts in, also it is too tight to get to the backside to just go with a smaller bolt and nut through the existing holes.. i will make new plates tomorrow...

i will likely sell this bumper and make a new one with hitch built in(:

post-639-0-93979300-1372211172_thumb.jpg

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...