Jump to content

ronin

Registered User
  • Posts

    156
  • Joined

  • Last visited

  • Days Won

    8

Everything posted by ronin

  1. This is going to be great
  2. ronin

    Zuk

    No , you don't have to weld the holes up . They will be fine .
  3. this thread is a year old but I just saw this on Pirate and had to share
  4. ronin

    Zuk

    Holy $#!T , there is enough there to build another one .
  5. finished up with the tire carrier I was working on . updated the build on NSJC to see details
  6. winch plate is on the bottom of the frame , tucking it in nicely . as for the grill , it's aluminum flashing left over from a job and I cut it out . If you look close you can see where I widened the ends out for the Samurai front marker/turn signal lights .
  7. no relays on Samurais but on the list
  8. fixed up the front bumper on the Sammy . I didn't like the "Stubby" look and it didn't offer any protection to the lower front . Before and after pics
  9. ronin

    Zuk

    Jay ,in this pic I trimmed the floor,firewall area back to the body mount to fit the 33's no more rubbing . always liked the look but as you know , I cant leave well enough alone
  10. Jay , the rotor is from a full kit I bought years ago from Spidertrax , they no longer make it . I bought a new caliper from Princess Auto as it was the same as the one in the kit . everything else is custom . http://www.lowrangeoffroad.com/suzuki-off-road-parts/samurai/brakes/suzuki-samurai-transfer-case-mounted-e-brake-kit-sb-ebk-lr.html this is the only one I found , the same as the one I bought except the rotor is different but its almost 3 times what I paid about 7 years ago
  11. got the e brake fabbed up and a cross member made for the Samurai and updated my thread on NSJC
  12. ronin

    Zuk

    any stamp collectors here ?
  13. ronin

    Zuk

    Sammy guys have been swapping the Tracker stuff out of the aluminum housing into the Samurai housing as the tracker front will crack under hard use . Google it to see what you will need to do it .
  14. Shiny is over rated
  15. ronin

    Zuk

    why pull it out , just add more to it , turn the thing into a raisin .
  16. ronin

    Zuk

    Jay, did you swap the gauge cluster from the other Samurai . The cluster should have a VSS which you will need in order to run properly .
  17. The silver makes your tires look bigger
  18. I got mine from a Ford dealer in Sydney a few years ago . I think they were around $40 for the pair at the time .
  19. got the shifters and boots installed and got started on the reworking the dash bar for the heater install
  20. Got the flex line for the clutch reshaped and installed ,welded up the clutch rod and put a shaft on the clutch peddle , topped up all of the fluids in the trans , T case and both diffs .
  21. got the clutch slave cyl mounted and started on the master . Plated the firewall and started mocking the rod . I'm using all 86 chev parts as that is what my transmission came out of . The master mounted on the fire wall is for mock up , looks good but seals are bad . Just have to weld the rod and drill a hole in the clutch peddle arm .
  22. distributor in , plugs , wires and sleeves
×
×
  • Create New...